Petzl Shunt Ascender

Price
$142.00
Taxes and shipping calculated at checkout

FREE US Ground Shipping on orders over $395 (up to 150lbs, excludes AK, HI & Freight)

Designed for the zip line enthusiast who needs to climb a series of steps or ladder rungs to reach their launch platform. It's a bit intimidating to climb up ten or more feet without being tied to a rope to prevent you from falling. The Petzl Shunt Ascender can be attached to a safety rope allowing the rider to climb a ladder or steps without risk of falling. Should the rider slip or fall, friction is applied which acts just like a brake.

Note: Does not include CarabinerRope or string for retrieval.

 

Not only do you get the Ascender, but you get the very best customer service in all the land.
If you're not happy, send it back for a full refund within one year.
  • A mechanical rope brake device for climbing to platforms that are higher than four feet off the ground.
  • Easy to retrieve, simply attach a string beforehand to the Ascender and from the ground give a little tug to the string after the rider has already launched off the zip line.
  • Keeps riders connected to the rope until they reach the launch platform.
  • Works with single and double ropes up to 10 mm.

FREE Design consultation

Want to talk with a specialist about your project?

Schedule a free 25 minute consult to help you plan your zip line project. Plus you'll receive a discount code to help with your order!

Zip Line University

Explore Our Knowledge Base

Installing a planning a zipline can seem like a daunting project. We're here to demystify the process!

Learn more about zipline installation

FAQ

How do I measure elevation change in my backyard?

Please refer to the manual that comes with your kit for specific installation instructions. 

Stand at the end tree and hold a 4 FT Carpenter’s Level like a rifle.  Holding one end up to your eye, point the opposite end at the base of the starting tree, right where the dirt and tree meet. Make sure the bubble is between the two hashes indicating level (crouch down if your yard has a minimal slope or climb a ladder if your yard has lots of slope).  

Once you have the level aiming at the base of the starting tree, measure from the Carpenter’s Level down to the ground.  This measurement is your natural elevation change.

If you have questions, please do not hesitate to give us a call at 888-476-3701

How do I figure out the slope for my zip line?

Please refer to the manual that comes with your kit for specific installation instructions.

The slope determines the speed of the zip line. Essentially this is the angle you set the cable at between the two trees. The slope is calculated by multiplying the distance between your trees times .03 or 3%.

More details on Slope can be found in the Zip Line Gear handbook included with your purchase. You can also view a digital version of the “Cable Slope & Sag” right here. We recommend finding a landscape with a natural slope of 3% to 6%, This is a 3’ - 6’ foot drop per 100’ feet. 

For zip lines that will NOT utilize a Bungee Brake System, (a Stop Block is NOT a braking system) the maximum allowable slope is 3%. For zip line setups that include a Bungee Brake, the maximum allowable slope is 6%. 

!!WARNING!! Zip line must never exceed 6% (6’ foot drop per 100’ feet) riding slope. High speed collision with end point may cause injury or death.

I don't have trees. Can I use posts?

Yes you can, but you need to carefully read the instructions for how to select, and install posts in the Backyard Zip Lines handbook included with your purchase. Alternatively, you can review the information in the digital version of our handbook right here.

If you are in any doubt as to how to properly select and install a wood post, please do not hesitate to contact us at 888-476-3701.

Recommended for You